Acer X110P: Projector Lamp Replacement Video Tutorial

In this short video you will see how to replace a bulb with housing in an Acer X110P projector. The procedure for other Acer models will be similar. In this demonstration, the entire lamp housing is replaced with a new one. If you have purchased a bare bulb without housing, have a look at the video on replacing bulbs in housing.

Subtitle transcription

  1. Turn off the projector by pressing the Power switch
  2. Let the projector cool down for at least 30 minutes
  3. Unplug the projector
  4. Remove the screws that hold the lamp’s cover
  5. Take off the lamp’s cover
  6. Remove the two screws that hold the lamp housing
  7. Pull out the lamp housing
  8. Unpack the new lamp
  9. Insert the new lamp and tighten it
  10. Return and secure the cover back in its position
  11. Plug the projector in and switch it on
  12. Perform a reset of lamp hours. After switching the projector on, go to: Menu > Management > Lamp Hour Reset. Press the button and choose "Yes" to turn the lamp hour counter to 0 hours.
Send the instructions on to your friends

All of our videos